Heads up for potential Modern Sporter purchasers.

Status
Not open for further replies.
I still haven't built my first set but I just had to get in on a second set because they are so beautiful. Nicely done gentlemen.
 
ATRS Shaun said:
No.An order placed right now, for a forward assist upper and lower set, is expected to be delivered in October.

Rick was refering to the last CNC mill that we purchased, it took three months from when we purchased it, to be installed and set up.
Click to expand...

Just in time for my birthday! XD
 
I think a better question would be, if we were requesting to have ATRS assemble rifles (including checking for headspace, installing barrels using reaction rods, handguard installation, LPK installation, etc), is ATRS willing to do this and how much would this service cost?

If we were looking to just have ATRS install a barrel on the upper receiver, what would this single service cost and when would we ship our parts?
 
They mentioned previously they can assemble rifles. Cost is $150.

correctaccount said:
I think a better question would be, if we were requesting to have ATRS assemble rifles (including checking for headspace, installing barrels using reaction rods, handguard installation, LPK installation, etc), is ATRS willing to do this and how much would this service cost?

If we were looking to just have ATRS install a barrel on the upper receiver, what would this single service cost and when would we ship our parts?
Click to expand...
 
Mik123 said:
I'm in the first run. I'm going to have you assemble my rifle. When should I send the parts to you?
Click to expand...

1st run lowers and SS uppers are done, so assuming that is what you ordered, send your parts anytime it is good for you.
IF you ordered the set with a F/A upper, we are still making them so they are not ready yet for assembly. As soon as we have anyones uppers or lowers done we contact them, at that point to send in parts sooner than later is suggested.
 
Thanks Rick. I'm on the first F/A upper run.

alberta tactical rifle said:
1st run lowers and SS uppers are done, so assuming that is what you ordered, send your parts anytime it is good for you.
IF you ordered the set with a F/A upper, we are still making them so they are not ready yet for assembly. As soon as we have anyones uppers or lowers done we contact them, at that point to send in parts sooner than later is suggested.
Click to expand...
 
alberta tactical rifle said:
We are expecting to be getting the first F/A uppers out for anodizing by the end of this month, so I would think ship us your parts in early to mid May.
Click to expand...

I ordered an upper and lower a month or so ago. The ones that are to be sent out end of September or so. Just curious, what happens if the government bans semi autos before then? I wasn't really worried then I buddy sent me a thread on it this morning here on cgn
 
Jamal86 said:
I ordered an upper and lower a month or so ago. The ones that are to be sent out end of September or so. Just curious, what happens if the government bans semi autos before then? I wasn't really worried then I buddy sent me a thread on it this morning here on cgn
Click to expand...
Thats literally impossible.
 
Regarding Trigger Tech adaptable triggers - can someone post a picture of the area that must be filed down. I understand it’s the area behind the adjustment screw but i’m not a 100 percent sure. Thanks
 
Status
Not open for further replies.
Back
Top Bottom