stickhunter
CGN frequent flyer
- Location
- Victoria, B.C.
Hi all,
I bought two scopes that came with rings, and I'd like to try to identify them, if possible. Both sets of rings are 30mm, steel, have 3 grooves in the cap and base, and a horizonatal relief cut at the ends of the base (presumably to stop pinching). They're similar enough that they may even be from the same manufacturer.
The first set have 6-bolt caps and two cross-bolts; the front and rear rings have matching serial numbers. The cross-slot bars are substantial and 0.193" wide for a Picatinny rail:
The second set are unserialized and have 4-bolt caps and have less substantial cross-slot bars, which are 0.120" wide.
Is there anything distinct about them that can match them to a manufacturer? I'd like to sell them, but would like to identify them first to determine a value.
Thanks!
I bought two scopes that came with rings, and I'd like to try to identify them, if possible. Both sets of rings are 30mm, steel, have 3 grooves in the cap and base, and a horizonatal relief cut at the ends of the base (presumably to stop pinching). They're similar enough that they may even be from the same manufacturer.
The first set have 6-bolt caps and two cross-bolts; the front and rear rings have matching serial numbers. The cross-slot bars are substantial and 0.193" wide for a Picatinny rail:
The second set are unserialized and have 4-bolt caps and have less substantial cross-slot bars, which are 0.120" wide.
Is there anything distinct about them that can match them to a manufacturer? I'd like to sell them, but would like to identify them first to determine a value.
Thanks!
Last edited:
