Help looking over my reloading supply list

Michael94 said:
I don't think that will work with the turret press, do you know any alternatives that will?
Click to expand...

The CH4D swaging die will work in any press guaranteed. Friend of mine uses on in a Forster Co-Ax.
I would NOT recommend it though... its expensive junk. He had issues with shearing off rims.

I you are going for volume and consistency, then I recommend a bench style like Dillion 600 super swage (RCBS also makes a bench style in addition to their die style).

Realistically, if you're doing low volume reloading, then you may be better off (economically) either using a hand tool mentioned previously... or just buying once fired and processed (usually swagged & FL resized) by the seller. Tonnes of commercially/professionally processed on the market at some reasonable prices.... I've never dealt with them but have heard good things about Black Sheep brass. Their prices seem OK too.
 
Hello everyone. So I bought everything I need. It ended up costing almost $1,500 in total, a lot more than I expected lmao.

I got the Lee turret press kits.
The 9mm and 223 die sets from Lee, and the respective case length gauges.
Frankford arsenal Tumbler
The Hornaday handheld reamer with small and large size cutters
Campro 9mm 124gr and 223 55gr bullets
Federal 205 primers
CCI 500 primers
Cfe223
Winchester 231

Thanks for the help everyone.
 
I have a few thousand rnds of 223 and 9mm. I don't anticipate prices going down anytime soon. Figure I'd start reloading before having to go thru my personal reserve.
 
You must log in or register to reply here.
Back
Top Bottom