help with aimpoint 3x magnifier

[FLUXCORE]

I picked up an aimpoint 3X magnifier with the twist mount and went to put it on my AR only to find out it sits a little low on my Bushnell holosight anyone know where I can pick up a small riser that can fit between the rail and sight.
Any suggestions would help.

 

[acrashb]

Your bushnell is likely lower-third co-witness. the aimpoint with that base is absolute co-witness.

It will still work (try it), but if you want them lined up you could look for a Larue LT755.

 

[FLUXCORE]

I think im going to want to bring it up a little so it lines up better with the holosight as for absolute co-witness with the my magpul flip sights im not to concerened. Im not even sure my rear flip sight will fit under my aimpoint I removed it and have yet to put it back on.

 

[edwin-97a]

call wolverine and ask for aimpoint 3x riser w/4 screws. it goes in the middle of the o ring.