Help with designing T1x chassis

Hat off, well done.

The shelf both sides for the pin looks like this on the stock we recently made, for left or right actions. T1 or T3.
DHqq7Fs.jpg


edi
 
Small shelf visible on your stock Paul, left and right on the original Tikka stock however not in the position of T1X pin. They did not want to build a new mould for the T1X? Had quite a few dropped pins and lost bolt catch levers on those stocks. We designed after the stock after the T1X was out.
edi
 
EJG said:
Small shelf visible on your stock Paul, left and right on the original Tikka stock however not in the position of T1X pin. They did not want to build a new mould for the T1X? Had quite a few dropped pins and lost bolt catch levers on those stocks. We designed after the stock after the T1X was out.
edi
Click to expand...

Sorry I edited my post and pic of OEM stock was removed since I see from some of his photos the OP has one.....

Don't recall the shelf on the KRG Bravo chassis I put the T1x receiver in, but I did that quite a while ago. You seem to build stocks so would know more about it than I.
 
I think we were probably one of the first who added a shelf on a stock to cater for T3 as well as T1. The little pin in the T1 is different to T3 as it is rifled to have extra friction as a quick solution. I never had an issue with my T1X with original stock but the pin falling out was mentioned on forums.
edi
 
You must log in or register to reply here.
Back
Top Bottom