Help with Fabarm Martial Pro Forces 14" ghost ring sights...

pazzo

pazzo

CGN Ultra frequent flyer
Uber Super GunNutz
Rating - 100%
206   0   0
It comes factory with the LPA ghost rings, and I have the rear fully bottomed and it’s still shooting high by several inches at 20 or so yards. The front sight is non-adjustable as far as I can tell (pic below to be sure).
Keep in mind, this is a 14" shotgun that I’m using for "close quarter" situations, so pls don’t suggest zeroing it at 100 yds. Lol.

Thanks.

 
Last edited:
If it's for close quarters "situations" what does a few inches high matter? Learn to hold under? The front sight is adjustable. That's what te star wheel is for. Rotate clockwise and it should lower your poi
 
Of course I can hold high, but that doesn't change the fact that these silly sights are bottomed out. It's due to the fact that rear ghost ring is factory mounted on the picatinny rail. Nice but not nice.

I'll mess around with the front sight later and see what happens.
 
it's a shotgun you shouldn't even need to use the sights at close range I suggest not using them just practice raise it up and shoot. Raise it up and shoot once you line it up with the target you won't need to aim at close range it's natural point of aim that matters.

The ghost ring in the back is so big that you have to put the dot in the middle to make it work right so I don't really use the sights I just line it up and go close enough and I hit targets just fine doing that. Also you might want to use buck shot it can spread a little more then a slug and counter the shooting high. Or you can just know it shoots the way and aim a tiny bit lower.

That's how I practice with my bear shotguns the first round is a bear banger the next ones is a rubber slug then the next one is winchseter pdx01.
 
You should still zero the gun beyond 20yards.
Try some variation in how you align the front post within the ring.
What sort of ammo are you using?
 
Thanks for the help everybody. My question was regarding the sights on this particular setup only, not how to aim or shoot.

Both my Benelli M4s with factory LPA ghost rings and both my Remington 870Ps with Scattergun Tech ghost rings have no issues zeroing up at 20 yds, but this Fabarm has the silly sights raised up too high as they are mounted on the factory rail. I like them but don’t like the limited adjustability.

I don’t mind zeroing at 50 yds or so, but even then I was a few inches high still. I’m telling you, the sights on this gun are awesome (LPA = f*cking rad) but the way they are mounted is kinda odd.

de-mix, I’m using slugs (and buckshot sometimes) - mostly 2 3/4" Federal, Winchester or Brenneke.
 
dieseldawg said:
The front sight is adjustable. That's what te star wheel is for. Rotate clockwise and it should lower your poi
Click to expand...


So I lowered the screw and it naturally raised the rear of the f/o sight. I had to actually lower it back down a few clicks as to avoid it from raising past the side protectors and getting smashed off. Looks funny now :D


 
You must log in or register to reply here.
Back
Top Bottom