Willy Tincup
CGN frequent flyer
- Location
- Owen Sound
I have a Domino 602 target pistol with 2 mags.
Mag A works fine.
Mag B sits up a bit higher and catches the bolt as it tries to close. The small hole near the bottom of the mag on the right side is larger than than the good mag [A] and I think [but not 100% sure] that is the problem. I believe the bottom part of the hole needs to be filled in so that the mag has to be inserted farther before the pin will engage and latch it in place.
Heres the question. How could one fill it in? Could the bottom portion be bridged with silver solder? Drill it out larger and make a bushing and have it welded in place? Trash it and buy a new one? Other?
I know some of you wizzards have some ideas on this. Thanks.............wTc
Mag A works fine.
Mag B sits up a bit higher and catches the bolt as it tries to close. The small hole near the bottom of the mag on the right side is larger than than the good mag [A] and I think [but not 100% sure] that is the problem. I believe the bottom part of the hole needs to be filled in so that the mag has to be inserted farther before the pin will engage and latch it in place.
Heres the question. How could one fill it in? Could the bottom portion be bridged with silver solder? Drill it out larger and make a bushing and have it welded in place? Trash it and buy a new one? Other?
I know some of you wizzards have some ideas on this. Thanks.............wTc
