Hi-Point 10mm Carbine

[cyclone]

Anybody else excited about this?


http://www.thetruthaboutguns.com/2017/12/jeremy-s/new-hi-point-10mm-carbine/


It's apparently going to be at Shot Show 2018 ...

 

[Fargone4sure]

Have one in 9mm, and one in 45acp, both are uber reliable, and pretty darn accurate. Have to admit i would be tempted by a 10mm.

 

[Gnome75]

I will be interested in these in any caliber if they can come in as non restricted

 

[cyclone]

I will be interested in these in any caliber if they can come in as non restricted

My thoughts exactly, regarding the 10mm ...

 

[cyclone]

I will be interested in these in any caliber if they can come in as non restricted

Another (less expensive!) 10mm in a non-restricted setup would be great.

 

[Fargone4sure]

A picture of the mods i did to one of my Hi-points

 

[B]

I'm definitely interested if they come NR.

 

[Repper]

View attachment 145834
A picture of the mods i did to one of my Hi-points

Looks great man! Did you make the barrel shroud? Just needs a Aimpoint t1!

 

[Fargone4sure]

Yes, I cut off the front of both the upper and lower stock. Moved the front site back, into an inlet I cut in the stock. Then machined two bushings to fit over the barrel, and drilled and tapped them for lock screws. Stopped by my local machine shop to pick up some tubing appropriate for the faux sound moderator. Cut out some end caps for it, that just fit over the bushings. Plasma welded the bushings into the end caps, and the end caps onto the tubing. Sand blasted the sound moderator, and with a splash of matte black, she was ready to go back together.

I have a 9mm version that i mounted a Leopold Delta Point on, but decided to just keep the irons on this one.

 

[Repper]

Yes, I cut off the front of both the upper and lower stock. Moved the front site back, into an inlet I cut in the stock. Then machined two bushings to fit over the barrel, and drilled and tapped them for lock screws. Stopped by my local machine shop to pick up some tubing appropriate for the faux sound moderator. Cut out some end caps for it, that just fit over the bushings. Plasma welded the bushings into the end caps, and the end caps onto the tubing. Sand blasted the sound moderator, and with a splash of matte black, she was ready to go back together.

I have a 9mm version that i mounted a Leopold Delta Point on, but decided to just keep the irons on this one.

That is awesome! A delta point is a great choice too. What a cool firearm.