high visibility follower- Win defender

[G_Money]

Hi,

I am trying to find a high visibility follower for my Winchester 1200 defender. I haven't had any luck finding one. However, I have found a high vis follower for the Remington 870. Is the mag follower interchangeable between these two guns?

Thanks

 

[12magnum]

That was my thought to. I don't really know if they can be interchanged.I would suspect that they probably can.It wouldn't cost much to find out.

 

[trubluscrew]

What about a can of hi-viz paint? Just take out the follower and give it a good spray. I can't see it being too badly rubbed (except for a small ring from the hull)

 

[CNADNSL8-5]

Contact Badboybeeson at S&J Hardware
Here is what you are looking for
http://www.sjhardware.com/Magfollower.html

Spring retaining shaft no spring binding Hi viz green color Will not crack break or absorb oils
Tested and will fit the following pump and semi auto shotguns in 12 gauge.
Remington 870, 1100, 1187
Winchester 1200, 1300, 2200
Mossberg 500,590, 835, 935
Norinco HP9
Maverick 88
Bennilli M1, M2

 

[G_Money]

Contact Badboybeeson at S&J Hardware
Here is what you are looking for
http://www.sjhardware.com/Magfollower.html

Thanks, I contacted Badboybeeson at the above website.

 

[Threemorewishes]

Hello G_Money,
If you dont find the flourescent one here's mine in white nylon. I made one for my 1300 this evening and it works perfectly. If you are interested shoot me a PM.
Threemorewishes

Installed...

Compared to the original part...

The tip of the magazine limiting rod has to be trimmed for the 3 inch shells...

 

[G_Money]

Hello G_Money,
If you dont find the flourescent one here's mine in white nylon. I made one for my 1300 this evening and it works perfectly. If you are interested shoot me a PM.
Threemorewishes

Installed...

Compared to the original part...

The tip of the magazine limiting rod has to be trimmed for the 3 inch shells...

That looks pretty sweet. I'll definitely contact you if i cant find a fluorescent one.

G