incorrigible
CGN frequent flyer
- Location
- stubble jumper
Heres how it came from Wolverine

and after a few minutes with a fore grip and some rails pre ordered from Dlask

But I hate the stock like I hated the SL8 thumbhole before it so I tore it apart knowing it had to go. So I flipped a jigsaw upside down and held it between my knees on the floor like a makeshift tablesaw to cut make the initial cut

and then the smaller cuts on the bottom chord that allowed it to bend straight


and cutting in a divot for the chord to be placed into (in retrospect I should have keyed this somehow...)

I glued the bottom chord with Devcon II Plastic Welder.


Then a little glazing putty and sanding

and some Textured Plastic black paint and presto (its not 100% dry/cured yet, 15 min after paint, but you get the idea) and Operation: Thumbhole Stock Be Gone is complete... I have to come up with a better name

Now I just sit back and wait for the upper to come back from the gunsmith to see how it goes together... and for the acutal UMP conversion kit to come in of course.

Excelllent....
.