Hornady LNL bushings

[ryanshaw44]

Does anyone know if the Hornady LNL bushing accept any brand of dies?

Thanks

 

[Bart212]

They accept the regualr standard dies but I forget what the thread is at the moment. I have RCBS Lee and Hornady and they all fit.

 

[gagreflex]

I'm pretty sure it's 1 inch -14Tpi. I use them with redding/rcbs/lee dies and they all work just fine!

 

[ryanshaw44]

Great , thanks guys. I have yet to pick up dies. Is there any that you would recommend?

Ryan

 

[HKMark23]

Does anyone know if the Hornady LNL bushing accept any brand of dies?

Thanks

Yep, in as much as you can get standard thread dies for any cal but a 50 BMG , pretty well anything goes. Besides the brands already mentioned, I have dies from EGW and Dillon fitted with the L&L bushings too. You certainly don't need to stick to Hornady dies if thats what you're concerned about .

 

[moosedude]

Great , thanks guys. I have yet to pick up dies. Is there any that you would recommend?

Ryan

Lee if you are on a budget, loaded thousands of 9mm before my decapper broke, from lack of attention on my part not the tool's fault. RCBS if you got the bucks, they are the best in my eyes but I'm sure others will have differing opinions.

Oh and if you can, get carbide dies cause lubing is tedious

 

[blaser.306]

7/8-14 is the standard thread on ( most ) reloadind dies. And yes the Hornady LNL bushings will work . When you get Em get lots ! You never seem to have enough, "If I just had one more "

 

[2Bad4u]

7/8-14 is the standard thread on ( most ) reloadind dies. And yes the Hornady LNL bushings will work . When you get Em get lots ! You never seem to have enough, "If I just had one more "

Good advise. And when you need them they are typically out of stock.