Hornady Single Stage Press Bench Mount

Cdnfd24

Cdnfd24

New member
EE Expired
Rating - 0%
0   0   0
Location
Beausejour, Manitoba
Hi folks,

I am doing basement renos. Got the storage room/reloading room half setup. I have a bench down there now. I want to mount my Hornady single stage press on the bench top and not have it overhang into drawer area. I have limited space and can't mount the press on the side. I'm looking for a Canadian supplier that has a bench top mount for the Hornady lock n load single stage press.

Also looking for a bench top elevated mount for the powder measure.

Any intel or a supplier please pm me.

Thanks much,

Neil
 
Try something like this.
http://i676.photobucket.com/albums/vv125/Creamysmooth1/Raw_zps616e8c78.jpg
Search strong mount in the reloading section and you will get a few options. Even if you do not have the tools to make something like this yourself it is fairly straight forward, and should not cost to much to have a welding shop fabricate something like this for you.What does get expensive is getting a 24 to Creamysmooth as a royalty payment.
 
Last edited:
I use the InlineFabrication Junior Ultramount with the quickchange system. I've got two presses and not much workspace so the quick change system is awesome.
The regular Ultramount has a 9 5/8" clearance. The Junior overhangs the benchtop and my LNL AP clears the drawers that are 5" lower than the top of my benchtop. I just measured it and it would clear your drawers that is 3 3/4" below the top of the bench. Unfortunately I don't think anyone sells them in Canada but they ship up here.

h ttp://inlinefabrication.com/collections/ultramounts
 
Trinimon said:
I use the InlineFabrication Junior Ultramount with the quickchange system. I've got two presses and not much workspace so the quick change system is awesome.
The regular Ultramount has a 9 5/8" clearance. The Junior overhangs the benchtop and my LNL AP clears the drawers that are 5" lower than the top of my benchtop. I just measured it and it would clear your drawers that is 3 3/4" below the top of the bench. Unfortunately I don't think anyone sells them in Canada but they ship up here.

h ttp://inlinefabrication.com/collections/ultramounts
Click to expand...

I'd get their led light system as well if your ordering from them.. makes seeing around the press much better..
 
silverfoxdj said:
I'd get their led light system as well if your ordering from them.. makes seeing around the press much better..
Click to expand...

LOL, now ya tell me! I found that out right after I had that puppy all setup and I can't find my darn magnetic work lamp that I used to have on my drill press. Grrrr! :p
 
Hi Guys .

I was just looking at the inline fabrication site you listed and it looks really awesome . How is it with getting it into Canada or do they have a distributor here in Canada

It looks better than the LEE tripod bench I was looking at
 
You must log in or register to reply here.
Back
Top Bottom