How DIP picatinny rail will hold on CZ-452

N

narada314

New member
Rating - 0%
0   0   0
Hello all

Before ordering DIP rail I checked CZ-452.

There are no screw holes on place where rail will go and yet there are screw holes on rail itself.
CZ-452 has some kind of "mini-rail" (?)

The only possible thoughts I have is that DIP's screws will push from the "mini-rail" and keep DIP rail in place.

Is it how it works ?

thanks for advice.
 
It's simple, the DIP picatinny rail slide on the top of dovertail rail and then you tighten up 4 screws on the top. You need the bubble level to level it while you tighten the screw. It's simple as that. The instruction come with rail explain how to tighten the screws.
 
I bought this rail for my 455 and I want to know if that's ok if I use the blue loctite instead of the purple?

I already have the blue and cannot find the purple. I've made a couple of place and only find the blue or the red...
 
Nik12 said:
I bought this rail for my 455 and I want to know if that's ok if I use the blue loctite instead of the purple?

I already have the blue and cannot find the purple. I've made a couple of place and only find the blue or the red...
Click to expand...

Blue Loc-Tite is fine... the screws "do" mark the receiver... a lead shot pellet is a good idea.
 
You must log in or register to reply here.
Back
Top Bottom