How do you sling an AR15 AR10 & WHY?
- Thread starter sidester
- Start date
Still alive
CGN Ultra frequent flyer
- Location
- Rainy mosquito infested part of BC
Be more specific. For what purpose and what type of sling?
Cranky Pants
CGN Ultra frequent flyer
A couple QD points for my WK rear is built in the stock and front is a grove tec item
Why? Because the rifle is NR and i'll be using it on coyotes this winter
Why? Because the rifle is NR and i'll be using it on coyotes this winter
Depends on your intended purpose ......myself I run single points at the end plate. That’s the best setup for quick transitions IMO.
Still alive
CGN Ultra frequent flyer
- Location
- Rainy mosquito infested part of BC
You can QD mount a single point sling off the end plate as 84wh1 suggests for CQB shooting. It’s very good if you do rifle/ handgun transitions. Bad thing is if you let the gun hang and you run, you will nut yourself bad! Even if you throw the rifle to the side, it will bang on you due to a lack of 2 point contact. Single points are excellent for transitioning to support side.
A lot of instructors teach and use the dual point. 2 ways of slinging a dual point. One is off the buttstock ( usually QDed on the right side of the stock for a right handed shooter) and the other on the hand guard. Some mount it way forward and others closer to the receiver. You have to experiment which works better for you.
Another way is to clip one end to the end plate castle nut and the other on the handguard. Again, you have to experiment. I find a sling off the end plate can interfere with you getting a grip on the pistol grip as the sling can get caught in your hand as you grab the grip.
Best way to test is put your full gear on and see what hangs up. Do exaggerated movements. Dual points are harder to transition to support side as the sling can choke you if you do it wrong. But they are easier to run with as they hug the body if configured properly. The Ferro Concept and Vickers slings have a toggle to let you adjust the length of the sling quickly so you have more freedom of movement.
Then there is my favorite. The convertible single/ dual point, like the Magpul MS-3/4 style. Gives you the best of both worlds as it quickly converts between a single and dual point for whatever purpose you want.
And forget about 3 point slings. Overly complicated unless you enjoy hanging yourself and there are better options now.
A lot of instructors teach and use the dual point. 2 ways of slinging a dual point. One is off the buttstock ( usually QDed on the right side of the stock for a right handed shooter) and the other on the hand guard. Some mount it way forward and others closer to the receiver. You have to experiment which works better for you.
Another way is to clip one end to the end plate castle nut and the other on the handguard. Again, you have to experiment. I find a sling off the end plate can interfere with you getting a grip on the pistol grip as the sling can get caught in your hand as you grab the grip.
Best way to test is put your full gear on and see what hangs up. Do exaggerated movements. Dual points are harder to transition to support side as the sling can choke you if you do it wrong. But they are easier to run with as they hug the body if configured properly. The Ferro Concept and Vickers slings have a toggle to let you adjust the length of the sling quickly so you have more freedom of movement.
Then there is my favorite. The convertible single/ dual point, like the Magpul MS-3/4 style. Gives you the best of both worlds as it quickly converts between a single and dual point for whatever purpose you want.
And forget about 3 point slings. Overly complicated unless you enjoy hanging yourself and there are better options now.
Last edited:
IF you're going to use a sling, then this. I agree 100%. Single point at the rear of the receiver most of the time, with the option (with proper QD bits) to switch quickly to 2-point if needed. Vickers BFG are good. Three-points suck. Though I actually prefer clipping my rifle directly to my vest/plate carrier rather than using a sling at all... REALLY depends on what kind of shooting you're doing.
Last edited:
I use two point, using QD mounts on the handguard and stock. I use to only run Blue Force Gear slings but now that I tried a Magpul, it will be my new favourite.
I try to avoid single point, it creates a pendulum of pain. Although it's easier to transition from right to left hand shooting.
I try to avoid single point, it creates a pendulum of pain. Although it's easier to transition from right to left hand shooting.
When you transition from primary to secondary be sure to "throw" your primary down and away to your support side to clear your junk and maximize economy of motion for the drawing of your secondary. This pushes the rifle down the support side of your body so that you can move more easily and get the secondary up without getting tangled up in the single point. Also, running a single point is not as comfortable if your dismounted.
I think this gets the point across. All my rifles are fitted with a BFG VCAS 221 sling. QD points on both ends and a burnsed socket allows me to convert it to a single point should I chose.
Typically, I run it off of the end plate and a socket close to the receiver. Gives me ample control when slung, but better control over mounting off of the stock. For me, it's the perfect way to sling a rifle.
2 point or nothing at all. Attached at QD points on either the stock or the end plate depending on if i'm wearing a loaded plate carrier or not, and a hook loop up front on the handguard for an HK hook. Ferro slingster is the only way to go, IMO
- Location
- Maple Ridge, BC
Why? Ever try peeing while holding a hot weapon? you only need to get burn once.
When attach your sling to your rifle secure the sling on the opposite side of each other, It will be more secure and snug when you have your rifle on your back.
When attach your sling to your rifle secure the sling on the opposite side of each other, It will be more secure and snug when you have your rifle on your back.
Walking in a field?
I would go 2 point.
Comfort and easier to go hands free and do other things.
Less chance for your mag and balls to get into an argument with each other.
Personally I run mine off the end plate on a swivel that allows for 2p or 1p and easy shoulder switching. but again, for shooting 'yotes thats not really a concern for you.
I would go 2 point.
Comfort and easier to go hands free and do other things.
Less chance for your mag and balls to get into an argument with each other.
Personally I run mine off the end plate on a swivel that allows for 2p or 1p and easy shoulder switching. but again, for shooting 'yotes thats not really a concern for you.
I think this gets the point across. All my rifles are fitted with a BFG VCAS 221 sling. QD points on both ends and a burnsed socket allows me to convert it to a single point should I chose.
Typically, I run it off of the end plate and a socket close to the receiver. Gives me ample control when slung, but better control over mounting off of the stock. For me, it's the perfect way to sling a rifle.
Nice rifle! How do you like that scope?
To the OP, a dual QD mount sling from a reputable company (Magpul for instance) is the best sling option.
DaveMachine
CGN Ultra frequent flyer
- Location
- That one place with a cowboy complex
I use this (https://www.skdtac.com/Emdom-E-MM-Gunslinger-Sling-p/e2m.101.htm) along with QD sockets (one up front, one on the same side of the stock as my primary shooting side). It allows me to do rifle/pistol transitions and stow the rifle so I can use both my hands.
