How to cast Lee slugs
- Thread starter yomomma
- Start date
Bassmaster
CGN frequent flyer
- Location
- WMU 48 - Whitetail country
I'm sorry Yo-Ma...I stopped watching after I saw the grease-mold...wtf
Bassmaster
CGN frequent flyer
- Location
- WMU 48 - Whitetail country
I lied....I had to see it
periculumnexnecis
CGN Regular
- Location
- Kébecistan
My knees hurt just watching him.
geotndtwine
CGN Regular
- Location
- Calgary, Alberta
Watch his other videos, next he shows how to use the propane stove to cook dinner for his family
- Location
- The Conservative part of Ontario
How not to do just about anything to do with casting!
Thanks Yomomma! I followed the video exactly, but I'm still having problems. Do you use axle grease for lubricating the mold each time? I only had bacon fat
aaaand I'm joking. I really hope no one followed this guy's tutorial. I beleive this quote to be applicable: "Don't believe everything you read on the internet" - Abraham Lincoln
aaaand I'm joking. I really hope no one followed this guy's tutorial. I beleive this quote to be applicable: "Don't believe everything you read on the internet" - Abraham Lincoln
Did he use a block of cheese for flux?
I couldn't watch the whole video..too painful. But I did check out the one where here puts the slugs in the hull (also painful)
He cuts the top off the hull, dumps the shot and puts the slug in the hull. He then melts the shot to make a slug.
Holy crap for the time and money spent he could buy quality ammo. He's special.
I couldn't watch the whole video..too painful. But I did check out the one where here puts the slugs in the hull (also painful)
He cuts the top off the hull, dumps the shot and puts the slug in the hull. He then melts the shot to make a slug.
Holy crap for the time and money spent he could buy quality ammo. He's special.
Last edited:
tylerjwitty
CGN frequent flyer
- Location
- Northern Ontario
Oh my....
