- Hornady Interlock 200gr RN
- claimed 2822 fps (22" barrel?) https://hsmammunition.com/by-caliber/
- 2880 fps mv from my Remington 798 24" 1:12 barrel groups pretty good
HSM .350 Remington Magnum ammo
- Thread starter 4fifty8
- Start date
A few retailers have it every now & again but don't see any in stock right now. However reloading brass is available: https://beaksandbrass.com/product/350-remington-magnum/
Or can be made from .338 Win Mag brass with a Redding forming die: https://budgetshootersupply.ca/product/redding-350-remington-mag-form-trim-series-b/
Works pretty good for me using Hornady .338 WM brass.
Or can be made from .338 Win Mag brass with a Redding forming die: https://budgetshootersupply.ca/product/redding-350-remington-mag-form-trim-series-b/
Works pretty good for me using Hornady .338 WM brass.
I am looking for the HSM 358 Win 225 gr SGK ammo and have had no luck. My bolt action likes it (0.6" avg groups @ 100 yards)
I had a friend who owns a gunstore check on availability, and his report back was that it is not being imported at this time. Not sure when they will be bringing in more.
I hope this doesn't last too long! I have a couple of rifles that love this ammo...my 250 Savage being another (0.209" avg groups @ 100 yards)!
I had a friend who owns a gunstore check on availability, and his report back was that it is not being imported at this time. Not sure when they will be bringing in more.
I hope this doesn't last too long! I have a couple of rifles that love this ammo...my 250 Savage being another (0.209" avg groups @ 100 yards)!
I have some HSM 350 mag brass but have had issues with it.
Factory loaded with 200gr TSX, I had mildly sticky extraction. Though it may be my rifle but have 100 percent eliminated that possibility. Got a hold of some Nosler and Remington brass and it functions perfectly.
Reloading with the HSM brass I had extraction issues. Backed the loads off to a low pressure(2500fps with an 225AB) and still have sticky extraction. Nosler and Rem brass at 2650fps with the same bullet function perfectly.
So if you happen to find any HSM brass I would pass on it. Just my experience. Maybe this batch was just too soft but I ended up with 60 HSM cases I can’t use.
Factory loaded with 200gr TSX, I had mildly sticky extraction. Though it may be my rifle but have 100 percent eliminated that possibility. Got a hold of some Nosler and Remington brass and it functions perfectly.
Reloading with the HSM brass I had extraction issues. Backed the loads off to a low pressure(2500fps with an 225AB) and still have sticky extraction. Nosler and Rem brass at 2650fps with the same bullet function perfectly.
So if you happen to find any HSM brass I would pass on it. Just my experience. Maybe this batch was just too soft but I ended up with 60 HSM cases I can’t use.
