Hi.
I am looking for an item to be made for me for an airsoft rifle and figured maybe someone here would know someone that can make it for me. It is for an airsoft rifle m4 platform. The threading on end of barrel is 14mm and while I can get mock suppressors that extend my barrel for if I want to add a longer inner barrel this is not what I want. I am looking for one that goes over the barrel to hide it so more of a shroud but looks like a silencer. I have design ideas in mind.
As of right now I know it has counter clockwise 14mm threading, (spin counter clockwise the flash suppressor when putting it on) and I would want it to be the dimensions that I have shown in this picture below.
I would want it to be 4cm thick externally. Want it in black and other designs to it to be discussed. Also I should mention that thickest part of barrel is roughly 2cm. Probably for design safe to make it like 2.1 cm. For where the bb comes out it needs to be 1.1 - 1.2 cm centered hole.
I have seen over the barrel ones but they are for paintball and they have a thicker barrel so you can see a gap when it is over the barrel of an airsoft rifle. The ones I have found for airsoft are way too long and usually for sniper rifles with long barrels.
Talking to people they said I need to find someone that could mill this for me and shouldn't cost too much to have done and said best option would be a gun site.
If anyone has any suggestions for who could possibly help make this for me please let me know. Also I am in Ontario.
Thanks (if this is not right section please direct me to right spot or move thread thanks)
I am looking for an item to be made for me for an airsoft rifle and figured maybe someone here would know someone that can make it for me. It is for an airsoft rifle m4 platform. The threading on end of barrel is 14mm and while I can get mock suppressors that extend my barrel for if I want to add a longer inner barrel this is not what I want. I am looking for one that goes over the barrel to hide it so more of a shroud but looks like a silencer. I have design ideas in mind.
As of right now I know it has counter clockwise 14mm threading, (spin counter clockwise the flash suppressor when putting it on) and I would want it to be the dimensions that I have shown in this picture below.
I would want it to be 4cm thick externally. Want it in black and other designs to it to be discussed. Also I should mention that thickest part of barrel is roughly 2cm. Probably for design safe to make it like 2.1 cm. For where the bb comes out it needs to be 1.1 - 1.2 cm centered hole.
I have seen over the barrel ones but they are for paintball and they have a thicker barrel so you can see a gap when it is over the barrel of an airsoft rifle. The ones I have found for airsoft are way too long and usually for sniper rifles with long barrels.
Talking to people they said I need to find someone that could mill this for me and shouldn't cost too much to have done and said best option would be a gun site.
If anyone has any suggestions for who could possibly help make this for me please let me know. Also I am in Ontario.
Thanks (if this is not right section please direct me to right spot or move thread thanks)
