I did it. Mod magpul bad lever
- Thread starter zelly
- Start date
DETAILS!!!!!!!
Nice! How did you attach it? Is it on firmly or is there some play?
I have been thinking about drilling a tapping a small hole in the bolt release lever and attaching it that way but I haven't worked up the nerve yet.
Nice! How did you attach it? Is it on firmly or is there some play?
I have been thinking about drilling a tapping a small hole in the bolt release lever and attaching it that way but I haven't worked up the nerve yet.
I will post some pics , but basically it is possible to shave down the inside of the back “plate” thin enough to be able to slide it behind the bolt release and the frame. I used a 4 inch disc grinder and just took my time. You shave both side edges square as they are design to fit the round release of an AR , you also do have to remove a slot in the top as it needs to sit low enough down on the bolt release to enter the trigger area. But it’s basically sits flush with it after install. Also their is a little bit of play that I used cardboard shims to take the sloppy ness out of. All and all. Works well and doesn’t look like a butcher job either. Can’t tell it’s been modded.
