heavenIsAlie
CGN Ultra frequent flyer
- Location
- Abbotsford
i found the problem after looking very closesly lol
not sure if you can see in the pictures, but the mag well angle is steeper than the frame angle so the front is hitting and that is why i cant push it up harder. i was putting it together right all these times it turns out.
so i figure i need to take a file/dremel and match angles so it sits flush, is that ok to do? also on that the rear of the frame sits slightly farther out that the mag well, am i ok to file that down to a slop so the mag goes in without hitting it?
not sure if you can see in the pictures, but the mag well angle is steeper than the frame angle so the front is hitting and that is why i cant push it up harder. i was putting it together right all these times it turns out.
so i figure i need to take a file/dremel and match angles so it sits flush, is that ok to do? also on that the rear of the frame sits slightly farther out that the mag well, am i ok to file that down to a slop so the mag goes in without hitting it?
