I might have damaged my extractor

K

Kable

Member
Rating - 100%
2   0   0
Somehow I got the bolt and all that jazz jammed up and stuck when i was performing some basic maintenance on my CZ 858.
I got it all unstuck but I noticed that the extractor "stay" looks alittle out of place ( it looks like it has popped out a bit ).

Can you guys tell me if this looks normal ? And if not, what can I do? ( I already tried pushing it in all back and get it to "snap" back to its original position, but it won't work.
* Maybe I'm just seeing things*

21j7lzt.jpg


312wb5e.jpg
 
Might help if you tear it down and clean it.

The reassembly can be a b!tch, but this video I put together might help
[YOUTUBE]Q-vSb4xpQBM[/YOUTUBE]

Another video (below) made by a board member DaveMachine might also be helpful. Depends on the length of your spring and/or spring pocket, his method doesn't always work since the plunger won't always stay in the pocket.
[YOUTUBE]L0V4K3ZmqcA[/YOUTUBE]

Good luck!
 
Dis-assemble the bolt & check the extractor detent spring and also the detent itself. Might have snaped the nipple that holds it in the spring or a coil could be bent. If these are the issue PM me and I'll mail you a replacement.
 
Thanks guys.

Last question of curiosity here;
What would happen if I fired the rifle without repairing this issue ?
Anything serious/dangerous ?
 
Failure to extract and you would probaly loose the extractor. Nothing major as I can see. But it may make your shooting time very limited.
 
You must log in or register to reply here.
Back
Top Bottom