I need a few .303 British cases full-length sized in Vancouver

[Knottybuoy]

Hey all,

I bought some .303 brass from a member here, some of it is once fired and not resized.

I only use a Lee Loader for .303 and so I don't have a press or a full-length die to size the once-fired cases properly for my Enfield.

Anyone local in Vancouver that might be interested in resizing these cases for me (approx. 40-50)? I trade you a 6-pack...?

Please PM me if interested...

 

[HIGHRPM]

Sure, PM sent !

 

[bearhunter]

Before you get them resized have you checked to see if they will fit into your chamber as is????? There is a very good chance that they will. If this is the situation, all you need to do is neck size with your Lee hand set and you will be good to go. This will also extend the life of your brass.

 

[Knottybuoy]

Before you get them resized have you checked to see if they will fit into your chamber as is????? There is a very good chance that they will. If this is the situation, all you need to do is neck size with your Lee hand set and you will be good to go. This will also extend the life of your brass.

I went through about half of the brass last night and was actually pleasantly surprised that there will be much less brass than what I first thought that does need full length sizing. Once I'm through if there's less than 10 (only 4 or 5 so far) then I'll probably just toss those.