I need Winchester 1300 Scope Mount #'s Please

[88 man]

I've looked on the Weaver web site for the mount #'s used on the Winchester 1300 shotguns that are drilled and tapped from the factory and all the site says is to use a " convertamount " which is not what I want.Does anyone have a set of mounts they could give me the mount #'s please ?
Thanks !

 

[BAC4]

I recently sold my 1300, but I believe that the Weaver mounts for the 336 fit the 1300. Call Keith Long in Bewdley or stop into Sail and speak to John(gunsmith). Either one of them should be able to tell you. Bac4

 

[88 man]

I'll stop or call Keith as I'm only a few minutes away.The other isn't a gunsmith imho !

 

[cdn1canhunt]

Don't bother scoping your 1300 unless you are willing to pin the barrel. Without pinning the tolerance between the barrel and receiver are not tight enough to offer any accuracy. At least that was my experience with red dot and reg scopes on my 1300 when first mounted a scope to it , would fire the first group ok then begin to open up after that then barely able to hit a 16"x16" board at 50 yrds. The irons were good to about 75yrd and could get about a 4" group. Due to the fact that the iron were mounted to the barrel directly.

 

[88 man]

I got the mount #.I'll try both with and without scope and see what happens.
Thanks for the replies !