Ideal kids' grouse gun

I have a 100yr old Cooey 12ga that I modded by cutting down the barrel to 18 and threading it for chokes (Pictured in my avatar).
I have half a dozen chamber reducers in a variety of cartridges including 410 and 9mm but I would sure love one that used my 9mm flobert ammo.
I need a 9mm rimfire bored far enough over to allow a central hammer strike to be a rim strike.
If I had that, I could delete my Anschutz bolt action and use the Cooey until i found an O/U
Im not sure of flibery pressures but I doubt they've very high from having seen a few different guns so chambered. A machine shop could likely make one. Take one of you adapters for external measurements and a empty flobert case for internal cutting
 
Want to keep a girl interested in pretty much anything.
- She's got to feel pretty...

If that means her own pretty hunting hat/boots/jacket... a pretty sling for the shotgun... or carving the stock... so be it!
My daughter says it has to be pink. So her next bday present will be a mdt chassis painted pink with purple highlights
 
Itd be nice if someone made reloading dies in .410 that you could use in an ordinary single stage press
You don’t need to resize brass cased .410 ammo. The advantage of it is that you glue in the shot cards and the brass basically lasts forever. Although a 6.5x55ai die puts a beautiful rounded edge on them. Ballistic products makes most of what you need to load shot shell in brass cases and has a Canadian dealer.

I’m a few years out from what you’re doing, m oldest is 5. But already acquired the guns. Started my oldest off with a rascal. Next will be a 500 .410 shockwave with a shorten but stock. After that is a 505 youth gun in 20gauge and a 22 hornet as their first “big” rifle.

I went the mossberg route because eventually they will get my 500/590 12ga as adults. Very happy with the youth mossbergs. But they were pricey

I’d also consider a savage model 42. Very versatile youth gun. Arguably safer to keep track of the state of it loaded/unloaded. As the adult this is your job.
 
Im not sure of flibery pressures but I doubt they've very high from having seen a few different guns so chambered. A machine shop could likely make one. Take one of you adapters for external measurements and a empty flobert case for internal cutting
I suspect one could be 3D printed to handle flobert pressures.
maybe with a steel sleeve glued in.
maybe i will make one out of round stock or a snap cap and see.
 
Took my first bunch of grouse with a Gamo .177 break barrel before I was allowed to go to .22 or 410. Me and my brother shot the air rifles every day over winter in the basement so we became pretty good at headshots practising with bottle caps for targets.
 
They have some children size upland vest and bags...
il_fullxfull.5380056224_br9m.jpg


A few years back, there was a amusing thread on adviser (or maybe it was RimfireCentral) about getting young (6-10) children interested in hunting.
You had everything from blaze orange princess outfit, with a magical wand to point birds... or blaze orange super hero kit, where your super power was finding birds... the consus was keep it fun.
 
Back
Top Bottom