IDPA questions about SSP...

[Protege]

Hello guys/gals,

Is it me or is the IDPA rulebook a bit vague?

For SSP

1) Am I allowed to reduce/increase the trigger pull weight to whatever weight I want? If not, what is the minimum trigger pull weight (IDPA rulebook does not specify this)?

2) In the IPSC rulebook, there is a diagram illustrating the borders as to where you can apply grip tape on the gun. IDPA does not have this, but allows grip tape to be used. Does this mean I can (for argument's sake) cover the entire frame in grip tape?

 

[Onagoth]

Idpa has no minimum pull weight provided it doewnt produce an unsafe firearm.

The back straps and front strap can be covered. ..can't recall about the slide though

 

[John in B.C.]

Does this mean I can (for argument's sake) cover the entire frame in grip tape?

Yes.

John

 

[RePete]

Look at rule 8.2.1.6 for grips.

And 8.2.1.3.7 for the trigger.

All clearly stated.

 

[Canuck44]

Slide too if you want.

Bob

 

[Protege]

Thanks guys. I'm more used to the IPSC book where it is very specific about trigger pull weights, etc, etc.

 

[Canuck44]

IPSC Production is the only difference ie requires a 5# minimum pull. USPSA and IDPA have no limitations on trigger pull for any of their divisions.

Take care

Bob

 

[VICIOUS]

HI;I tried grip tape on the frame. It eats meat off your fingers ,not good.

 

[Canuck44]

HI;I tried grip tape on the frame. It eats meat off your fingers ,not good.

I have put skate board tape on the back of the grip on my CZ's and on the face of the front of the grip and it has been ok. My M&P's have skate board tape on the bgrips and again it isn't bad. I guess it depends on what you are looking for. I'm not sure, in my case, it has helped or hindered much. If it is cutting into your hands than I would say it isn't worth the effort.

Bob