I'm done!

desporterizer

CGN Ultra frequent flyer
Rating - 100%
229   0   0
Location
Toronto
I got some time off at Christmas & decided to stop ignoring that pile of brass I had in the corner of my garage. So here is the equation, 80lbs of lead, 6lb of powder, 2500-3000 gas checks, 2.5 tubes of lube + alox, 3000 primers (not everything was loaded with lead) & a crap load of time to aneal, trim, size, tumble, cast & finally load = 2500rnd rifle cast, 500 rifle jacketed, 500 45 acp.

Two observations, 1 the lee 10 lb pot can't keep up, i need a 20 & 2 my new auto index press held up just fine. Loading cast is the only way I could afford to do this.
 
I'd say you got it right. Whats the problem?


Nobody actually saves money by reloading. You simply get a sh*t pile more shooting for the same amount of money.
 
I gotta get heat in the garage!

Way behind on my casting and therefore everything else. Its just way too hard to want to go out and do that when never even hits -10 in the winter anymore.
 
Lets see some pics of these boolits!

Ok, lets see if you recognize the profiles.
DSC08793.jpg



& the pile
DSC08790-1.jpg

DSC08791.jpg
 
Back
Top Bottom