I had posted that my S&W Model 41 was giving me an ulcer when it finally gave up the ghost and wouldnt extract any longer. Wneh I stripped it down, I found that the extractor plunger had been driven back into the slide face and I could not get it to release. I then read the following link recommending Wortners Gun Works in Chatham Onatrio:
http://www.canadiangunnutz.com/forum/showthread.php?t=55501&highlight=wortner
Called and talked to George, explained the problem and that I was in the middle of our club match. I sent the slide and then the pistol down and I had it back in just over a week, fully repaired and test fired to boot.
Very pleased with the service and the quick turnaround - went and shot a 279 in one match today!
Highly recommend this place if you have a cranky Smith and Wesson!
http://www.canadiangunnutz.com/forum/showthread.php?t=55501&highlight=wortner
Called and talked to George, explained the problem and that I was in the middle of our club match. I sent the slide and then the pistol down and I had it back in just over a week, fully repaired and test fired to boot.
Very pleased with the service and the quick turnaround - went and shot a 279 in one match today!
Highly recommend this place if you have a cranky Smith and Wesson!
