Installed a Mr Fly trigger on a CZ455...now the bolt is flacid :-(

[chrisward3]

As the title says.

Just installed the trigger and while the bolt locks up tight in the down position, as soon as I squeeze the trigger, the bolt handle will bounce up about 1cm and then from there you can shake it and it will move freely that cm or so.

The bolt lift is still the same (less the initial slack) in order to recock the weapon and cycle the bolt.

Any thoughts on what is causing this?

 

[45CAT]

Go to the rimfire forum in the States, lots of problem solving with the Fly trigger. Me I’m sticking with my Yo-Dave kit

 

[FLHTCUI]

https://www.canadiangunnutz.com/for...FLY-TRIGGER-Who-is-running-then-in-your-CZ455
Sounds like the bolt needs a little blue pill.
Till then check out the thread mention above this text.
Rob

 

[RabidM4U5]

Nothing unusual, all CZ455's do this to a degree. Once the tension is released from the striker (which applies pressure to the bolt handle in the cocked position), the bolt handle is free to rotate until the cocking ramp engages the striker again.

 

[chrisward3]

problem solved.

user error...lol