Installing an A2 Birdcage on a Derya TM22

[dearslayer]

Got this flash hider the other day for my Derya TM22. It's more of a just for looks kind of thing, so are there any particular suggestions on installing it to get it torqued down to line it up properly ( grooves at the top ) . Should the threads get any type of anti seize compound or anything like that??

 

[Jay]

Got this flash hider the other day for my Derya TM22. It's more of a just for looks kind of thing, so are there any particular suggestions on installing it to get it torqued down to line it up properly ( grooves at the top ) . Should the threads get any type of anti seize compound or anything like that??

My Dlask AR15 birdcage flash hider came with a crush washer & no, anti seize compound is NOT needed.

Jay

 

[dearslayer]

Mine also came with the crush washer. Only reason I asked about the anti seize is because I had watched the below You tube video where they put some "Aero Shell 33 MS grease " on the threads. I thought that was a little weird.

https://www.youtube.com/watch?v=fC5C4URJTcE

 

[45CAT]

Grease is good. You may want to clean it in the future. Choke grease is good

 

[dearslayer]

Would wheel bearing grease be any good?

 

[ZREXER]

I see you got the upgraded charging handle from Dlask as well. I added it and it is so much better than the stock charging handle on the TM 22.

 

[dearslayer]

Just getting around to installing this birdcage. When I spin in on and it seats on the crush washer its already just about in it's correct position. I only have to apply a small amount of torque to make it snug but then it's just 10 degrees past being centered. Does this mean I should torque it to go one more complete revolution to line it up?