JP captured buffer loose in buffer tube ? Bcl102

[870supermag]

So I bought a ar10 buffer from JP but when installed it is loose in the buffer. Did I buy the wrong one? It's the large frame ar10 gen 2.

 

[Hutchy]

Loose as in slides back and forth not flush with the end of the buffer tube? If so you have to drop that white spacer down the tube.

 

[Neil Burke]

If it's only slightly loose in the extension tube (ie nowhere close enough for the plastic spacer) add a quarter or two into the tube first. It'll tighten up.

 

[CODFan]

What buffer tube are you using?

- Rifle length
- Carbine Length
- the “in between” that comes with the BCL102

 

[870supermag]

I'm running the stock buffer. There is not enough room to fit the space provided. It's about a inch from touching the retention pin. Can I just cut the white spacer that the kit comes with to fit? It is supposed to sit at the same place as a stock buffer would right?

 

[Dr. Hunter]

The buffer tube that comes with the bcl 102 is between a carbine and rifle. You can cut the white spacer to fit or throw in some quarters

 

[870supermag]

Thanks alot I will give the spacer a chop.