So I take my new Jw-103 bush ranger to the range for the first time and try it out. Well first thing I noticed after loading up a clip with surplus 7.62x39mm was that the damn bolt would not close. So I stop using it, bring it home clean it again and drop in a go-gauge and the bolt closes fine.
So back to the range I go (good thing it is only 10 min away) This time it closes but is real stiff. Pull thi trigger and it goes boom, great it works. Then I try and cycle the bolt and chamber another round and it jams! After careful inspection I noticed that the magazine is not held in place by the magazine latch. So I push the mag up and it does lock in but not strong enough. So I tired the other two mags that came with the rifle, same problem. Guess now I have to change the magazine latch spring, that is if I can find one. Will have to make one I am sure. (sounds like $$$ at the local gunsmith
)
So much for my $200 toy.
Anyone know besides the remington any other 7.62x39mm bolt actions? The bush ranger is going to drive me mad!
So back to the range I go (good thing it is only 10 min away) This time it closes but is real stiff. Pull thi trigger and it goes boom, great it works. Then I try and cycle the bolt and chamber another round and it jams! After careful inspection I noticed that the magazine is not held in place by the magazine latch. So I push the mag up and it does lock in but not strong enough. So I tired the other two mags that came with the rifle, same problem. Guess now I have to change the magazine latch spring, that is if I can find one. Will have to make one I am sure. (sounds like $$$ at the local gunsmith
So much for my $200 toy.
Anyone know besides the remington any other 7.62x39mm bolt actions? The bush ranger is going to drive me mad!





















































