Hey anyone have the K&M neck turner, I just wanted to double check if the I got the cutter in the right orientation. I was able to practice on a few cases I had lying around and it seem to cut but I just want to be sure. Working my way up to turning the expensive Lapua brass.
Also if cutting the shoulder a little bit is the cutting bit suppose to be in a different orientation?
The K&M's website is piss poor with their description and adjustment. 6mmBR site doesn't turn up much either good instruction but no detail about the cutter. Any photos would be apperciated.
Also if cutting the shoulder a little bit is the cutting bit suppose to be in a different orientation?
The K&M's website is piss poor with their description and adjustment. 6mmBR site doesn't turn up much either good instruction but no detail about the cutter. Any photos would be apperciated.
