K100 - range report #2

Hi Jaro,

I have a question: the 'problem' you described earlier and the solution of grinding/cutting/etc parts of the gun would not be legal in Production... I wasn't clear on what you said: is it the case that your current pistols have a different shape part and no longer experience the problem, or if it that they still experience the problem and need to be manually 'fixed' to work with the low capacity mags?

Thanks!
 
omen said:
Hi Jaro,

I have a question: the 'problem' you described earlier and the solution of grinding/cutting/etc parts of the gun would not be legal in Production... I wasn't clear on what you said: is it the case that your current pistols have a different shape part and no longer experience the problem, or if it that they still experience the problem and need to be manually 'fixed' to work with the low capacity mags?

Thanks!
Click to expand...

Hi Omen,
The sollution of the problem we talk about is fulle legal, because it is only pulishing and is not made the change to operational parts. As I said this pulishing to a cartridge manger is recomended only in case of using these 10-rounds magazines. At the presend produced K100 has this mentioned edge curved by radius R2-R3. And the problem with following of cartridge by using of 10-round magazines does not appear yet.
Regards,
Jaro
 
What are folks using for holster/ mag pouches for this gun? I am under the impression that since it uses Cz mags, the mag puches for the CZ will do, but what for holster?????
 
I'm going to try and get my new CR Speed holster to fit it, I don't imagine I won't have too much of a problem with that ;-)
 
You must log in or register to reply here.
Back
Top Bottom