KAC 45° Offset Sight Kit

[pbr streetgang]

It's crummy being a lefty shooter sometimes. Hard to find gear, and lots of accessories are righty only.

the Dueck defence are ambi

 

[lone-wolf]

What happens if you have a wall and a close target that requires you to use the irons on your right hand side?
Wouldn't this lead you to expose more of your body and rifle
I can sse this being great for left side of a wall targets tho. Just not completely sold on the whole off set sight hype.

Soon they'll have them with sights at 45degrees off both sides.

 

[25mm]

Looks awesome let us know how good it works

 

[Runt]

Very interested in how they perform as well.

 

[rivetc78]

i just picked the Dueck Defense 45 degree irons up for $200.00 and i really like them as well, but i would happily give the KAC a try if the price was right.

Are they available in Canada? Or did you find them elsewhere?
That is a great price.

Do you have a pic of them on your Rifle/Carbine?

 

[KiLLGiLL]

can they be set up for left handed shooters?

Interested

Edit: should of read the whole thread, answer on page 2 lol

 

[Donster 125]

what sling mount do you have there?

 

[pbr streetgang]

Are they available in Canada? Or did you find them elsewhere?
That is a great price.

Do you have a pic of them on your Rifle/Carbine?

DS Tactical...

I'll throw them on a rifle and take a pic when I get a chance

 

[jjohnwm]

How do these attach to the rail? The Dueck sights have an obvious clamping screw on the side, but I can't see anything on the KAC sights to clamp them to the rail.

 

[Boomer686]

It's crummy being a lefty shooter sometimes. Hard to find gear, and lots of accessories are righty only.

'cause it's a RIGHT man's world..

Why Righty always tryin' ta keep da utha Man down???




Nice sights though. I was considering some offsets the other day. I must say I am interested....

 

[Denka]

It is attached to the rial via screw
I removed 2 screws that one holds sights to the weapon's rail and another that I though it holds sights on the rail and tried to slide that off, I did not have any luck. It might be sitting tight or something was used as loctite or I am not sure. I will try to provide photos as well. It just does not make any sense to have one screw underneath the sights that will not give option to slide that sight off the rail

 

[KevinB]

They can be removed -- its just a #####.

They dovetail into the base.

 

[deets]

Is this the best sight for tactical tasking?

 

[00Buck]

Is this the best sight for tactical tasking?

I can tell by his reading material...

He knows what is best in life!

 

[Dmitri]

Ok, i received the sights and i have a bad news. the rear sight doesn't work with Vltor MUR-1 and VIS uppers due to unusual forward assist design, unless installed over the ejection port, or if you dont have a forward assist.... And also, the front sight will not work with YHM Dimond Series hand guards (or any other H/G that has a round profile like YHM.. I think..) And with my luck i got both.. mur-1 upper and YHM h/g.

So i'll have to put these aside for my next project....

 

[mebiuspower]

^You just need to get the MUR-1S (Shell deflector only).

 

[Dmitri]

yes i thought about it, but i kinda want the forward assist, and also where would i put the front sight...? I dont think i'd change the H/G just for that...