Kel-Tec RFB

[hbean]

Kel-tec doesn't even have enough for the American market. You guys will probably get the RFB about the time a Tavor reaches the American market.

RFB production batches still not at full quantities due to power limitations. Working with FPL to increase electrical capacity to utilize new CNC machines to bring RFB into full production numbers.

That was back in March, chances are they have resolved their electricaql problems and all the machines are running at full production numbers.

 

[Vault Distribution]

Kel-Tec has had a new CNC machine for the last a few months, dedicated to just producing RFB's which has helped with production.

 

[Sniper1]

Wooa... thanks for the info Vault D.

Now must think about selling my M14

 

[B]

Kel-Tec has had a new CNC machine for the last a few months, dedicated to just producing RFB's which has helped with production.

So when is The Shooting Edge going to be carrying these guns?... Good on you for taking up the importation of these rifles.

 

[Crossbones]

Any new info?

 

[Kc.338Lp]

Any new info?

me too very interested..

 

[Jay]

I'll be on this rifle "like a fat kid on a smartie", WHEN it shows up!!!

Cheers
Jay

 

[Brordo]

I'll be on this rifle "like a fat kid on a smartie", WHEN it shows up!!!

Cheers
Jay

Now, now...no pessimism...think positive (like the lottery)...dreaming is half the fun!!

 

[fireball]

I wouldn't expect they can bang out more than 1 completed unit a day. Put me down for 1 it'll be my retirement present in 20 years.

 

[bear.23]

I wouldn't expect they can bang out more than 1 completed unit a day. Put me down for 1 it'll be my retirement present in 20 years.

Huh??? not quite sure how you could make that assumption.

 

[Bracketman]

Huh??? not quite sure how you could make that assumption.

Actually, he's probably not too far off! They've been out in the US for the past two years and I believe there are less than 1000 on the market.. so they're not cranking out that many per day.

 

[bear.23]

Actually, he's probably not too far off! They've been out in the US for the past two years and I believe there are less than 1000 on the market.. so they're not cranking out that many per day.

Actually Keltec has bought 3 new CNC machines that were installed in their new building last quarter.. yes they've been in production for 18 months.. and have shipped about 1200 units.. But that's with limited machine time....

I would expect that they are producing a lot more then 1 a day now...

 

[hbean]

Huh??? not quite sure how you could make that assumption.

Welcome to the age of internet where news never gets old, everyone thinks they are the first one to read or hear something

 

[tootall]

Welcome to the age of internet where news never gets old, everyone thinks they are the first one to read or hear something

Aint that the truth.

 

[acrashb]

have shipped about 1200 units

Highest serial number spotted in the wild is in the 790's.

 

[bear.23]

Highest serial number spotted in the wild is in the 790's.

Could be, I though I saw a post last night from May about shipping the 1000th unit..

Not that it matters.. They are aware that it's a hot item and that they are slow to ship them and have expanded capacity to deal with..

That was my point..

 

[Epoxy7]

Huh??? not quite sure how you could make that assumption.

Seems fairly accurate so far. I'm also looking forward to one of these. But have been for what, 3 years now?