kinetic puller that handles WSM ?
- Thread starter Amphibious
- Start date
I had to use my RCBS® Pow'r Pull® Bullet Puller to pull 50 rounds of 270 WSM a month ago...
Are we talking about the same device?
It comes with 3 collets: small (223), medium (308) and large base collet (magnums).
Alex
pulling bullets
Another approach is to use your press. Put the round into the shell holder and raise it until the bullet protrudes. You can use pliers to grasp the bullet, and then lower the case.
You will often cause some damage to the bullet. However, I have used a rubber band wrapped around the bullet or tape on the bullet, and that decreased the damage. Take your time--apply steady constant pressure.
Obviously, a proper bullet pulling collet would be ideally suited for the job.
Good luck
Therion
Another approach is to use your press. Put the round into the shell holder and raise it until the bullet protrudes. You can use pliers to grasp the bullet, and then lower the case.
You will often cause some damage to the bullet. However, I have used a rubber band wrapped around the bullet or tape on the bullet, and that decreased the damage. Take your time--apply steady constant pressure.
Obviously, a proper bullet pulling collet would be ideally suited for the job.
Good luck
Therion
that's effing ghey
I've used both the kinetic and collet type pullers. The collet type is head and shoulders better than the kinetic.
Of the collet types, I've used the both the RCBS and Hornady. The Hornady collet puller is a perfect piece of kit and would certainly work well on a short mag. If lost, I would replace it immediately and wholeheartedly recommend its purchase to anyone needing a puller. Bullets are pulled out easy and unscathed. It is a better collet puller than the RCBS.
.
