krinker plinker stock set

The pistol grip has a section cut out of it to fit the contour of the ruger trigger guard.But it is a real AK piece,just modified
The butt stock doesn't attach to a trunnion like an ak,its just screwed in by the sides,so drilling 2 holes through a wood ak unit would allow you to attach it
There is no upper hand guard on a krinker,just a little heat shield,but a modified sks upper can be used to give it the appearance you're looking for.
 
I've been wanting to do this on my Krinker as well, i just never knew what i needed and what mods they would need once i got them lol. Could you describe what i would need to order or acquire then in a nutshell, what i would need to do to make it fit on my krinker? I would greatly appreciate the help. :redface: :D

Thanks

Rob
 
Well you could order the lower handguard,and buttstock(milled receiver) wood from here:
http://www.ironwooddesigns.com/2aprod/1zAKproduct.html
Install the lower,pull the folder out and push the wood butt in and mark the holes,drill the holes in the butt and screw it in.
Then find an sks upper handguard on the E&E,work it untill it fits and looks proper
 
Last edited:
Converted my first generation Krinker Plinker about 2 years ago. The upper handguard is cut down from an SKS... took about 5 minutes. The drill press to drill holes to attach the butt stock took another minute. Easy conversion... tighter fit than the original parts.

krinkerplinker_1.jpg
 
###y set up. you got the butt stock on back words? would look nicer the other way around, mind you your scope is mounted high so i guess it works out
 
You must log in or register to reply here.
Back
Top Bottom