Well Heres mine.
Cheap Tasco Red Dot, Fake Can for a barrel shroud project and cheap Chinese bipod. 300rd feedbox ( the firing pin is removed for pictures )
Now Rocks FH, Matech Rear Sight RRA Front, Custom Ammo Can.
After receiving the Feedbox and unimpressed I made my own at work. It was too long and you need a 12-25" bipod for it to work.
Started as a Alum 7.5" x 4" Alum Tube, Cut some alum and welded end caps.
Then I made a roller cam setup so keeps the belt from twisting when firing. But realized it was a PITA to load the belt so I cut the top open. Then I realized forgot to notch it to clear the AR15 magwell. So notched it and welded a piece in. Shes drilled and holds onto the Razorback Brass catcher with SS bolts and washers.
I gotta work on the roller cam setup because its hard to get the tab thru when full loaded.
Still needs to be fully painted OD Green.
Cheap Tasco Red Dot, Fake Can for a barrel shroud project and cheap Chinese bipod. 300rd feedbox ( the firing pin is removed for pictures )
Now Rocks FH, Matech Rear Sight RRA Front, Custom Ammo Can.
After receiving the Feedbox and unimpressed I made my own at work. It was too long and you need a 12-25" bipod for it to work.
Started as a Alum 7.5" x 4" Alum Tube, Cut some alum and welded end caps.
Then I made a roller cam setup so keeps the belt from twisting when firing. But realized it was a PITA to load the belt so I cut the top open. Then I realized forgot to notch it to clear the AR15 magwell. So notched it and welded a piece in. Shes drilled and holds onto the Razorback Brass catcher with SS bolts and washers.
I gotta work on the roller cam setup because its hard to get the tab thru when full loaded.
Still needs to be fully painted OD Green.
