I'm experiencing feed problems in my XCR when using my Lar15 magazine. I'm typically finding that the teeth are a little too wide and usually the last round will pop out. Has anybody encountered this before? I'm planning on buying another Lar15. Maybe its just my magazine. Has anybody else had this problem?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Lar15 feeding problems in XCR
- Thread starter Gobc
- Start date
Just bend the mag lip back into shape.
I will have to try that. Can't make it any worse than it is now.
Ty
bad lar15 mag
i had one that did that when it was brand new but it was in my ar rounds kept popping up so i looked at it recharged it shifted my hand off the back rib where the spot welds are and sproing out flew all the rounds two of the welds were bad returned it for another one all the others have been good.
tornado45
i had one that did that when it was brand new but it was in my ar rounds kept popping up so i looked at it recharged it shifted my hand off the back rib where the spot welds are and sproing out flew all the rounds two of the welds were bad returned it for another one all the others have been good.
tornado45
I just measured the width of the teeth between the Lar15 and the magpul. I gently hammered the teeth about 1mm closer and tested with dummy rounds. Seems to be working good. Looking forward to going again. (just went today). I think I will pick up a second one soon.
As much as I like the pmag, you just can't ague with double the capacity.
Sigh, our gun laws suck.
As much as I like the pmag, you just can't ague with double the capacity.
Sigh, our gun laws suck.
