How about let's start a thread about tips and techniques for loading which will do the trick, but you won't find in any "written directions"
Let me start this out.
#1
To anneal brass.....
Borrrow/ use your lead furnace.
When the pot is full of molten lead....
Dip the neck of the case you wish to anneal into the molten lead.
HOLD THE CASE HEAD WITH YOUR BARE FINGERS.
When the casing becomes too hot to hold with your bare fingers, drop it into room temp. water.
Should work out just fine.
I have done literally thousands this way without a glitch.
#2
Want a really neat case lube??? soluble and effective??? 50/50
Anhydrous lanolin, and Mineral oil.... heated and blended.
Also works as a bullet swaging lube. See Corbin Mfg.
#3
When bullet seating for accuracy with conventional dies..... Seat bullet 1/2 way. Rotate casing 90 degrees, finish seating.
Improves concentricy without cost of special dies.
here's your chance folks...... Bring them on !!!!!!
Thegunnut
Let me start this out.
#1
To anneal brass.....
Borrrow/ use your lead furnace.
When the pot is full of molten lead....
Dip the neck of the case you wish to anneal into the molten lead.
HOLD THE CASE HEAD WITH YOUR BARE FINGERS.
When the casing becomes too hot to hold with your bare fingers, drop it into room temp. water.
Should work out just fine.
I have done literally thousands this way without a glitch.
#2
Want a really neat case lube??? soluble and effective??? 50/50
Anhydrous lanolin, and Mineral oil.... heated and blended.
Also works as a bullet swaging lube. See Corbin Mfg.
#3
When bullet seating for accuracy with conventional dies..... Seat bullet 1/2 way. Rotate casing 90 degrees, finish seating.
Improves concentricy without cost of special dies.
here's your chance folks...... Bring them on !!!!!!
Thegunnut
