Lee collet die issue

R

ragu123

Member
Rating - 100%
6   0   0
Location
southeast ontario
While I was reloading a few rounds the other day I accidentally pushed to hard on the rockchucker and stripped the threads on my collet die cap.
question is where can I find a replacement? I've spent about an hour searching the net trying to find a Canadian lee dealer who has them but no luck yet.
If someone could help me out I'd appreciate it!
Thanks
 
Email Lee and tell them your problem and they might send you a new cap for free.

Then go to the Doctor and have your arm calibrated in "INCH POUNDS".

In the meantime here is an idea to fix the problem until the Doctor can cut 90% of the tendons in your arm.
(if the duct tape rips your pulling too hard)

torquepress_zps80ffd788.jpg
 
Pretty sure Lee will replace the part at no charge. When neck sizing, you don't need a whole lot of force. Follow the setup instructions for proper neck tension and you won't break 'em anymore. :)
 
I just ordered some parts from a non-supporting dealer. I needed decapping pins and clamps for used die sets that I bought that didn't have them. If you can't find Lee parts in Canada you aren't searching very hard IMHO.
 
You must log in or register to reply here.
Back
Top Bottom