let me see your cheek risers... need ideas.

It's an add on cheek riser for a CAA ar buttstock no mods required to it as it mounts to a picatinny rail, just bolt rail onto stock and it just slides on!
 
Shooting edge Calgary,site sponsor and good price/service. the rail section needs to be the type with the gap down the middle.
 
I was using one of the kydex diy ones and it would not tighten enough so it would still move about an 1/8 or so. So I hit ebay and got a magpul ctr riser (most likely fake, but it was $10)

I just finished mounting it and it look great and should not move at all. The two holes in the stock were from the previous cheek riser so I had no problem adding 4 more lol.

20121217_132131.jpg

20121217_132039.jpg

20121217_131938.jpg


All that is left to do is counter sink the hex bolts for it to be really clean.

Shawn
 
You must log in or register to reply here.
Back
Top Bottom