Lets see some pics of your tactical shottys!
- Thread starter mmatt
- Start date
The wood stock on top, is it a Winchester or Ithaca?
Are the 2 1301 identical beside the tube extension?
The multicam one, is it a Turknelli M4?
Winchester 1200 on top, then Ithaca 37 (1947) and 21" gen 2 1301 Comp, Canuck Operator, 870, 24" gen 2 1301 Comp.
24" is brand new, just got on Thursday. Kenny autoloading lifter and tube extension en route.
The 21" is bone stock with extension and a printed matchsaver, about 4k through it and hasn't skipped a beat without cleaning.
Only shot target loads through it, mostly the cheapest stuff I can find.
I wouldn't mind getting a tighter choke for it but the supplied ic unit has worked well for me as all of my targets are within 25 yds or so as my range is set up.
Buddy printed me a bag full of matchsavers, cost a couple dollars vs buying for 30+ apiece.
24" is brand new, just got on Thursday. Kenny autoloading lifter and tube extension en route.
The 21" is bone stock with extension and a printed matchsaver, about 4k through it and hasn't skipped a beat without cleaning.
Only shot target loads through it, mostly the cheapest stuff I can find.
I wouldn't mind getting a tighter choke for it but the supplied ic unit has worked well for me as all of my targets are within 25 yds or so as my range is set up.
Buddy printed me a bag full of matchsavers, cost a couple dollars vs buying for 30+ apiece.
Last edited:
Greenhorse six
CGN Ultra frequent flyer
A little ghetto, but fun.
I modified the hogue grip to use a Magpul Receiver Sling Mount and have a GG&G sling point at the front.
I modified the hogue grip to use a Magpul Receiver Sling Mount and have a GG&G sling point at the front.
Last edited:
I've been mucking about with my SBE. Latest addition has been a longer MLOK M1/M2 handguard from Toni System in Italy. With some minor fitting it fits great, and very tight against the barrel. My only possible gripe is that it's such a thin grip that the barrel lug and rings block a few slots from being mounted. Almost a non-issue as most grip panels can bridge that gap.
*edited to add; IF you're using the Toni System handguard (atleast on an SBE), make sure to swap over the shims from inside the handguard to the Toni model. The ones provided were very weak and the handguard shifted forward about 1mm. Not much, but it shouldn't move at all. The OEM shims fill the gap properly.
Last edited:
That battleworn woody is something else.
- Location
- ON, North of GTA
Very nice!
charliediep0
Member
- Location
- The universe
- Location
- ON, North of GTA
Thats ~4lbs in ammo alone
I was thinking about those 30 round mags today. That is something to carry.
charliediep0
Member
- Location
- The universe
Yes I have, but not as often as I'd like. The weight is obnoxious but it soaks up recoil well. That carry handle is a must
