Lets see some pics of your Tacticool VZ 58/858s

[TV-PressPass]

Got this back from North Sylva!

 

[Luis1]

Pretty.

 

[G.Mitchell]

Here is my newest setup, this handguard is a permanent addition now since I had to modify the rifle to make the handguard work. All credit for the handguard mod goes to mattcwc

 

[incorrigible]

Here is my newest setup, this handguard is a permanent addition now since I had to modify the rifle to make the handguard work. All credit for the handguard mod goes to mattcwc

Interesting mod work on the handle...

 

[StrikerSW]

Got this back from North Sylva!

Thats a nice setup, I have been considering getting that FAB Defence folding stock. Is that the polymer joint, and if so how do you find it?

 

[TV-PressPass]

Thats a nice setup, I have been considering getting that FAB Defence folding stock. Is that the polymer joint, and if so how do you find it?

It is the polymer setup, and I really like it! But in this setup I pretty much use it as a fixed stock. Because the stock folds to the left the optics mount is occupying the same real-estate. My primary purpose with a stock like this is to have the cheek riser adjustment between optics and irons.

 

[StrikerSW]

It is the polymer setup, and I really like it! But in this setup I pretty much use it as a fixed stock. Because the stock folds to the left the optics mount is occupying the same real-estate. My primary purpose with a stock like this is to have the cheek riser adjustment between optics and irons.

Thanks for reply and information.

 

[seamus]

Mine, right before selling to Mike.

What type of muzzle brake is that?

 

[diablo_man]

...

 

[Luis1]

Here is mine until I can do an ejector mod for my vz to allow the full top rail to work. Need to get another ejector though just in case.

 

[Cone_Skid_Cone]

What type of muzzle brake is that?

It appears to be the birdcage brake from Dlask. I run an identical set up, except for the unicorn - wooden upper handguard.
(A6)

 

[saskcop]

Here is mine until I can do an ejector mod for my vz to allow the full top rail to work. Need to get another ejector though just in case.

What forend is that? Nice looking rig.

 

[Luis1]

Thanks! It's the fab defence aluminum forend, ordered it from zahal.org, same as the one that is on TV press pass vz a few posts up. Very nice fitting forend and rock solid.

 

[mattcwc]

My new vz.

 

[Bonjour43ma]

Might put a fibre optic or tritium insert in the front sight... and hope it shoots as good as it looks! Sight radius is very short but we'll see

 

[id64]

Where did you get this barrel shroud?

 

[Bonjour43ma]

It was a custom job by a local smith.

Where did you get this barrel shroud?

 

[P0WERWAGON]

what is that front sight?

 

[Bonjour43ma]

It's a UTG subcompact rear aperture sight meant for shotguns lol. I looked for something with windage and elevation adjustments and randomly came across it. I did have to dremel the aperture down to a triangle shape, but the hole that was already on the sight actually lines up with the rear sight set at 100. Pure luck! Going to try putting in a fibre optic insert this weekend and see how it shoots. Bore sighted it already but usually that's off by a little bit.

 

[mt666tm]

That Zhukov front end mod is really nice, swallows up a lot of that front barral sticking out... looks like I have something new on my to-do list.