I was on the Limbsaver site and printed off the templates to make sure of the one that was needed. I checked the Mossberg 500 ones first, all were wrong (to big or to small). The part # 10112/10121 and #10200/10201 are listed for a Mossberg. The one that fit was Part #10601, this firearm was bought brand new a month ago. Was there changes made to the stock? Or is it a miss print on the Limbsaver site. Has anyone else come across this problem?
Limbsaver Recoil Pad for a Mossberg 500??
- Thread starter fralic76
- Start date
Besure that you printed them off to the correct size .I printed them off as well and they didn't print to the correct size the first time .measure the the actual tempplate to be sure it printed to actual size.do you have a wood or synthic stock as the numbers you listed are for a synthic stock.
I did print them off at full size, double checked with a measuring tape. They are the right size. I have just print the templates for the Kick Eez recoil pads and going to check them tomorrow to see which one fits. Does anyone have a Kick Eez pad on their firearm? If you do what do you think about them. Which one is better for felt recoil (Limbsaver or Kick Eez).
Beretta687EELL
CGN frequent flyer
- Location
- SW Ontario
Most of them have to be ground to fit.
Beretta687EELL
CGN frequent flyer
- Location
- SW Ontario
Limbsavers are good pads, I had one on my Beretta at one time. I use Kick-eez exclusively, mainly because that is what all of the people that do stock work install. I think Kick-eez is the standard that all others are measured to.
