I suppose you are quite right. I think there would be quite a few other chamberings that would outsell a 9.3x57.
That 275 Rigby with 24" bbl is a nice combo. What would the difference be between the Lipseys version and the ones that EPPS has?
Lipseys Ruger No.1A 275 rigby
- Thread starter Slimbo
- Start date
That 275 Rigby with 24" bbl is a nice combo. What would the difference be between the Lipseys version and the ones that EPPS has?
- Location
- In the shadows of the Rockies
Should be the same since No.1 rifles are Lipsey's Distributor Exclusives -
http://www.ruger-firearms.com/products/no1DE/models.html
http://www.ruger-firearms.com/products/no1DE/models.html
Fit is fine overall, but in my opinion, I would go with a lower ring combo than what comes stick with the #1......... I am sure it would be functional, but from an aesthetics point of view it would make the scope look higher than it has to.....
It's a good fit for this rifle. Mounted as far forward as possible -
Based on this, supercub may want to ignore my last....... I based my opinion on the 1b's I had and forgot about having to clear the rear sight on the 1a's.....
I found the #1 very forgiving for cheek weld..... and not sure what slamfire was using in the pics......
If oem, will it clear the rear sight if you go down a ring size?...... yes, it's a .11 difference, but I ask more for my own knowledge than anything else...
- Location
- In the shadows of the Rockies
My 7.62x39 1-A with #4 rings. Oops, previous image is with #3 rings. Needed #4 rings for my 45-70 so I took it off my 416 Ruger Alaskan since I had a spare #4 SS. 
Yes it's on my to do list to get a set of #3B rings.
Yes it's on my to do list to get a set of #3B rings.
- Location
- Lloydminster, Alberta
My 7.62x39 1-A with #4 rings. Oops, previous image is with #3 rings. Needed #4 rings for my 45-70 so I took it off my 416 Ruger Alaskan since I had a spare #4 SS.
Yes it's on my to do list to get a set of #3B rings.
Love the 7.62X39. very few were made. Made with the 'left over' 303 brit barrels was what we were told by lipseys.
My 7.62x39 1-A with #4 rings. Oops, previous image is with #3 rings. Needed #4 rings for my 45-70 so I took it off my 416 Ruger Alaskan since I had a spare #4 SS.
Yes it's on my to do list to get a set of #3B rings.
Give Snapshots a call @ 1-450-427-0052
- Location
- In the shadows of the Rockies
- Location
- In the shadows of the Rockies
A unique chambering for sure in a No.1. Shoots not too bad with .311 150gr bullets.
7.62x39 groups at 100 meters off the bench rest
