Load ranges for .270WSM 140g Barnes TSX/TTSX

[MuleyMadness]

I have been reloading my .270wsm with Reloader 22, Federal 215 primers, and Barnes 140g TSX but due to the grotesque shortage of powder I can't find any RL22 anywhere in BC. I can however locate some RL19 and RL25 so I was wondering if anyone had any safe load ranges for either with this combo. I figured I would try it out (and be smart enough to buy a pile of it this time if it works). Any suggestions, or actual experience would be greatly appreciated. Also if anyone knows where I can buy some RL22 that would be spanktacular.

 

[killswithkimber]

Usually if you are in a pinch when looking for load data for barnes x bullets you can call the manufacturer and they have all the ranges on file, I have done this a time or two . It might not hurt to even go to the barnes website and see if the post data.

 

[Mighty Peace]

Remtumbo is what I use for my 270WSM's with 140gr Accubonds...LOVE IT

Was going to load the 140gr TSX's too but the AB's were performing great at the range and on big game.

I keep my RL22 for my 300WM.

 

[BC Bigbore]

Another fan of the .270WSM/140gr Accubond combo. I boot them outta the tube with enough Reloder 19 to sizzle across the skyscreens at just under 3200fps with no pressure signs.

 

[MuleyMadness]

Thanks everyone. I will try calling or emailing Barnes about it. I did check their site before posting and they didn't have any load data, which isn't particularly surprising as they can't test every bullet/load combination. And I'm sure the Accubonds perform superbly, I have never had anything but great success loading any Nosler product, both in the accuracy and the performance categories, but seeing as I already have a 100 Barnes bullets sitting there I was wanting to find a powder to use with em. Yesterday I was lucky enough to scrounge a couple of pounds of RL22..which should get me up to hunting season at least.