First attempt,I won't put up my data however PM if you want. So new Magtec brass
Rem.LP primer
IMR 4227 ( the only power I have for this )
430ga nitro card 0.125 thick over powder
430ga.1/2 fiber wad
255.0 grns. #7 1/2 shot
450ga. overshot card
white glue to seal
Slug
Rem. LP primer
IMR 4227 powder
430ga. .125 nitro card
125 grn. Thug slug
450ga. overshot card on 1 slug
I used my 30-06 cal. Lee crimp to crimp the brass it seems to work.
I shot 1 slug and 1 shot load so I could look at the brass. Did not pattern or shoot for accuracy .
Hard to see but there is a small bulge in the case from the slug load other than that no problems.
When I get a chance to pattern and put the slugs on paper I will post again.
Question should I anneal the brass if I am going to keep on crimping?
Rem.LP primer
IMR 4227 ( the only power I have for this )
430ga nitro card 0.125 thick over powder
430ga.1/2 fiber wad
255.0 grns. #7 1/2 shot
450ga. overshot card
white glue to seal
Slug
Rem. LP primer
IMR 4227 powder
430ga. .125 nitro card
125 grn. Thug slug
450ga. overshot card on 1 slug
I used my 30-06 cal. Lee crimp to crimp the brass it seems to work.
I shot 1 slug and 1 shot load so I could look at the brass. Did not pattern or shoot for accuracy .
Hard to see but there is a small bulge in the case from the slug load other than that no problems.
When I get a chance to pattern and put the slugs on paper I will post again.
Question should I anneal the brass if I am going to keep on crimping?
