Loading for the 9.3x62

kombi1976

kombi1976

CGN frequent flyer
EE Expired
Rating - 100%
2   0   0
Location
NSW Australia
I got my Tikka T3 Lite Stainless a couple of weeks back and now am just waiting on the Lapua brass to arrive.
The two powders I have easy access to are Varget and H4895 so I'll use one of them, probably Varget.
I got some Speer 270gr Semi Spitzers as the Speers I've used in the past were always decent and these were the cheapest projectile by far.
Is anyone else loading this bullet in their 9.3x62?
Which powder are you using?
Are you using magnum large rifle primers or standard large rifle primers?
 
kombi1976 said:
I got my Tikka T3 Lite Stainless a couple of weeks back and now am just waiting on the Lapua brass to arrive.
The two powders I have easy access to are Varget and H4895 so I'll use one of them, probably Varget.
I got some Speer 270gr Semi Spitzers as the Speers I've used in the past were always decent and these were the cheapest projectile by far.
Is anyone else loading this bullet in their 9.3x62?
Which powder are you using?
Are you using magnum large rifle primers or standard large rifle primers?
Click to expand...

While I haven't hunted with the 270 gr Speer in my 9.3X62, I have developed loads for it using Varget.

My starting load was 58 gr for a MV of 2440 fps and my max load was 60 gr for a MV of 2500 fps. These velocities were with a 24" barrel.

Brass was Norma and the primers were CCI 200(large rifle).

Generally speaking, accuracy was very good
 
I had the H4895 on hand when I was using my x62 and found it to be great. I used CCI250s but I doubt it was needed.
That was with 250gr Accubonds and 270 Speers. Didn't do a whole bunch of testing but had 1 1/4" groups most of the time, the speers doing better than the noslers.
 
You must log in or register to reply here.
Back
Top Bottom