These powders, as well as H4895, will generate the correct gas port pressure to cycle the action w/o damaging the rifle. As a bonus they will provide excellent accuracy. A person need look no farther.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Loading the M1 Garand problem
- Thread starter ryan9991
- Start date
These powders, as well as H4895, will generate the correct gas port pressure to cycle the action w/o damaging the rifle. As a bonus they will provide excellent accuracy. A person need look no farther.
mcpherson284
Regular
- Location
- Vancouver Island
Almost a perfect video to explain it. Pity it doesn't show a right hand side view. Slide all four fingers down the right hand side of the stock (in front of the op-rod cocking handle) while pushing down with your thumb. When the En-block locks in place sweep your hand towards the front sight and up and the same time. Trying to up straight up or moving your hand out and away from the right side can cause the op-rod cocking handle to catch your hand. This will NOT hurt you, but it may cause the bolt to hang up on the first round. Should this happen, bump the op-rod cocking handle with the palm of your hand in a down and forward motion. Should you try a slapping up and forward motion, you can cause the op-rod to lift out of the receiver guide track and jam.
