Look what Santa brought!

[Gatehouse]

Just unwrapped it and mounted it on the bench, so not much to look at yet.....But when I get some time and I can sneak away to the shop, it will be transformed to this

 

[MikeyD895]

that is a nice set up

 

[silverfoxdj]

Congrats the bullets will be flying in 2021

 

[dead meat]

Unwrapping presents before xmas morning, for shame.

 

[Hrsplit]

I will be buying this set up but I want the motorized version , just load it and read a book

 

[Buckmastr]

Looks like a bench mounted factory. Pulling that lever repeatedly will also provide much needed post Christmas exercise.

 

[Gatehouse]

I will be buying this set up but I want the motorized version , just load it and read a book

I'm in a debate over the auto drive. They cost almost the same as another 1100 set up. I currently have a Hornady Ammo Plant set up for 45 ACP.

So I am considering auto drive for the 9mm 1100 to crank out 1200 rounds per hour while I pull the Hornady handle and make about 500 rounds per hour. Or get another 1100 for loading 45

I guess I could get an autodrive and a 45 conversion kit. Pump out 50K 9mm then swap to 45 and do the same. Would only have to swap over twice a year then. Hmmm....This thread can get expensive.

 

[The Kurgan]

That is some industrial grade gear! Well done. That lever looks like it will also help build your biceps.

 

[Paul15]

I think Santa got mixed up, that was supposed to come to me. Lol.

Have you tried it out yet?

 

[yomomma]

Throw on your tootoo and get that bad boy cranking

 

[horseman2]

Actually it was a mix up in the order. Jewelry was ordered and this is what they sent!

 

[Buckmastr]

 

[Gatehouse]

Just did the final set up with the magnetic powder check die and then some mucking about and setting up and running a few test loads I started with a full primer tube and cranked out 100 rounds in 4.5 minutes. Not too shabby.